Diodes AH1895 - Manual (Page 3)

AH1895
Document number: DS35742 Rev. 1 - 2
3 of 10
www.diodes.com
July 2013
© Diodes Incorporated
NEW PROD
UC
T
AH1895
Absolute Maximum Ratings
(Note 6) (@T
A
= +25°C, unless otherwise specified.)
Symbol Parameter Rating Unit
V
DD
Supply Voltage (Note 7) 6 V
V
DD_REV
Reverse Supply Voltage -0.3 V
I
OUTPUT
Output Current (source and sink) 3.5 mA
B Magnetic Flux Density Unlimited
P
D
Package Power Dissipation
X1-DFN1216-4 230 mW
SOT553 230 mW
Ts Storage Temperature Range -65 to +150 °C
T
J
Maximum Junction Temperature 150 °C
ESD HBM Human Body Model (HMB) ESD capability 8 kV
Notes: 6. Stresses greater than the 'Absolute Maximum Ratings' specified above may cause permanent damage to the device. These are stress ratings only;
functional operation of the device at these or any other conditions exceeding those indicated in this specification is not implied. Device reliability may be
affected by exposure to absolute maximum rating conditions for extended periods of time.
7. The absolute maximum V
DD
of 6V is a transient stress rating and is not meant as a functional operating condition. It is not recommended to
operate the device at the absolute maximum rated conditions for any period of time.
Recommended Operating Conditions
(@T
A
= +25°C, unless otherwise specified.)
Symbol Parameter Conditions Rating Unit
V
DD
Supply Voltage Operating 1.6V to 3.6V V
T A
Operating Temperature Range Operating -40 to +85 °C
Electrical Characteristics
(@T
A
= +25°C, V
DD
= 1.85V, unless otherwise specified.)
Symbol Parameter Conditions Min Typ Max Unit
V
OL
Output Low Voltage (on) I
OUT
= 1mA — 0.1 0.2 V
V
OH
Output High Voltage (off) I
OUT
= -1mA V
DD
-0.2 V
DD
-0.1 — V
Ioff Output Leakage Current V
OUT
= 3.6V, Output off — < 0.1 1 µA
I
DD
(awake)
Supply Current
During ‘awake’ period,
T
A
= +25°C, V
DD
= 3V
— 2.1 — mA
I DD (sleep)
During ‘sleep’ period,
T A = +25°C, V DD = 3V
— 2.5 — mA
I
DD
(avg) Average Supply Current
T
A
= +25°C, V
DD
= 1.85V — 4.3 8 µA
T
A
= +25°C, V
DD
= 3.6V — 7.2 13 µA
Tawake Awake Time (Note 8) — 50 100 µs
Tperiod Period (Note 8) — 50 100 ms
D.C. Duty Cycle — 0.1 — %
Note: 8. When power is initially turned on, the operating V
DD
(1.6V to 3.6V) must be applied to guaranteed the output sampling.
The output state is valid after the second operating cycle (typical 100ms).