AEG F45020VI1P - Manual (Page 23)

1) The pressure and the temperature of the water, the variations of the mains supply, the
options and the quantity of dishes can change the values.
2) The appliance senses the degree of soil and the quantity of items in the baskets. It
automatically adjusts the temperature and quantity of the water, the energy
consumption and the programme duration.
3) This programme has a high temperature rinsing phase for better hygiene results. During
the rinsing phase, the temperature stays at 70 °C for at least 10 minutes.
4) With this programme you can wash a load with fresh soil. It gives good washing results
in a short time.
5) With this programme you have the most efficient use of water and energy consumption
for crockery and cutlery with normal soil. (This is the standard programme for test
institutes).
6) Use this programme to quickly rinse the dishes. This prevents the remaining food to
bond on the dishes and bad odours to come out from the appliance.
Do not use detergent with this programme.
Information for test institutes
For all the necessary information for test performance. send an email to:
[email protected]
Write down the product number (PNC) that is on the rating plate.
5. OPTIONS
Activate or deactivate the op-
tions before the start of a pro-
gramme. You cannot activate or
deactivate the options while a
programme operates.
If one or more options are set,
make sure that the related indi-
cators are on before the pro-
gramme starts.
5.1 Multitab
Activate this option only when you use
the combi detergent tablets.
This option deactivates the flow of rinse
aid and salt. The salt indicator stays off.
The programme duration can increase.
How to activate the Multitab option
1. Press and hold, at the same time,
button and button until
the Multitab indicator comes on.
If you stop to use the combi
detergent tablets, before you start to
use separately detergent, rinse aid
and dishwasher salt, do these steps:
1. Set the water softener to the highest
level.
2. Make sure that the salt container and
the rinse aid dispenser are full.
3. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
4. Adjust the water softener to the wa-
ter hardness in your area.
5. Adjust the released quantity of rinse
aid.
5.2 Acoustic signals
The acoustic signals operate when the
appliance has a malfunction, when the
adjustment of the level of the water soft-
ener occurs and when the programme is
completed.
By default, the acoustic signals are on,
but it is possible to deactivate them.
How to deactivate the acoustic signals
1. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode, refer to
‘Setting and starting a programme’.
2. Press and hold, at the same time,
button and button until
ENGLISH
23