AVSL Citronic CLA-1460 - Manual (Page 8)

171.220 User Manual
Active Amplifier Module with DSP
The internal amplifier in the sub unit is optimized for use in conjunction with the 4 passive array
speakers with built-in stepless variable fan cooling, overload protection and short-circuit protection.
The rear panel features a power switch and single rotary volume control with PEAK LED. If this LED
lights more than momentarily, the amplifier is liable to clip and the volume control should be reduced
until the PEAK LED lights only for an instant each time.
Input signal is processed via a DSP circuit for dynamics and EQ control, helping to protect the system
and tailor the tonal response to the venue or particular application. A CDROM is included containing
PC editing software for the CLA-1460 processor section. Connection to a PC can be made using USB,
RS-232 or RS-485). See “Software Application Guide” for further information.
1. Power switch
2. IEC mains inlet
3. Mains fuse (replace only with approved type)
4. Speaker output connectors (pin 1+ hot, pin 1- cold) parallel linked
5. USB port
6. RS-232 port (9-pin D connector)
7. RS-485 input/output (digital XLR)
8. Rotary VOLUME control
9. PEAK LED indicator
10. LINE signal input/output (XLR)