AVSL Citronic CLA-1460 - Manual (Page 4)

171.220 User Manual
Assembly
The CLA-1460 may be assembled as a single vertically flown array, inverted as a floor-standing stack
or combined into a multiple array. Assembly for standard flown orientation is shown below.
1. Secure the 4 U-rings to the flying frame. Each must be securely fixed using the appropriate
hardware to ensure that there is no movement of the fixing or possibility of becoming unfastened
through movement or vibration and should be suspended from a permanent fixing in the ceiling
which is adequate for holding the weight of the complete line-array.
2. Securely attach the flying frame to the upper sub by connecting the M8 locknuts through the sub
pulling plate at the front edge and connecting the array bracket on top of the sub to the central
brace of the flying frame.
3. To connect an array cabinet underneath the sub cabinet, detach the ball-catch bolt from the
front pulling plate and align with the bottom of the sub pulling plate on each side and replace the
bolt through both.
4. Connect the Passive-Active Link bracket from the bottom of the sub cabinet to the rear of the
topmost array cabinet.
5. Connect further array brackets below via the front pulling plates and connect at the rear with
rear angle adjustment brackets (Angle adjustment is explained in the “Installation” section)
6. Assemble the array as shown below