AVSL 154.095 DM-X24 - Manual (Page 9)

8/19 USER MANUAL
4.White holding Record, press the Flash button corresponding to the DMX output that you wish
to assign the Fader to.
5.Repeat steps 2-3 as often as necessary
6.Press and hold Record & Rec Exit to exit the mode.
Al physical faders can be re-assigned to output on a different DMX channel, Faders are given
a channel number and are labelled on the surface of the controller as such.
You can check to see what the assignment is by pressing the Fader button of the
corresponding channel while in this mode.
Here is no limit to the amount of channels that can be assigned to a single faders. One can
assign up to all 48 channel while in this mode.
CHNO corresponds to the Physical Fader, while SLDNO corresponds to the DMX output
channel.
NOTES:
For example: you wish to assign Fader #1 to
output to DMX channel #5
1. Hold the Record button & press Fader#6 (3
times)
2. Press the Flash button #1.
3. While holding the Record button, press the
Flash button #5.
DMX 512 CONTROLLER SERIES