AVSL 154.095 DM-X24 - Manual (Page 15)

14/19 USER MANUAL
8) While holding down RECORD, tap the REC EXIT button to exit MIDI setting.
Notes: This is process of copying show to another same 48 CH dimmer console. This will not work with
any other device.
This process can take several minutes to complete.
This control will automatically being the FILE DUMP once the mode has been
selected.
Therefore, be sure that the other deceive has preciously been setup to receive the transfer.
During FILE DUMP, all other operation will cease to function.
If errors or power failure occurs, FILE DUMP will be interrupted and stop.
Sending MIDI File Dump
Action
9) While holding down the RECORD button ,simultaneously tap Flash #4 three times, the display
reads MIDI FILE DUMP SENDING 000%when the device is in correct mode.
10) While holding down RECORD, tap the REC EXIT button exit MIDI setting.
Notes: This is the process of copying your entire show to another same 48CH dimmer console .
This will not work with any other device.
This process can take several minutes to complete .
The control will automatically being the FILE DUMP once the mode has been selected.
Therefore, be sure that the other device has previously been setup to receive the transfer.
During FILE DUMP, alI other operations will cease to function .
If errors or power failure occurs, FILE DUMP will be interrupted and stop.
6.APPEMDIX
DMX Primer
There are 512 channels in a DMX 512 connection. Channel may be assigned in any manner. A
fixture capable of receiving DMX 512 will require one or a number of sequential channels .The user
must assign starting address on the fixture that indicates the first channel reserved in the controller .
There are many different types of DMX controllable fixture and they all may vary in the total number
of channels required, Choosing a start address should be planned in advance, Channels should never
overlap. If they do ,this will result in erratic operation of the fixture s whose starting address is set
incorrectly. You can however, control multiple fixtures of the same type using the same starting
address as long as the intended result is that of unison movement or operation, In other words, the
fixture will be slaved together and all respond exactly the same.
DMX 512 CONTROLLER SERIES