AVSL 154.095 DM-X24 - Manual (Page 10)

9/19 USER MANUAL
4.PROGRAMMING
CREASE A PROGRAM
Action
Action
1) Record enable
6) Press and hold RECORD
2) While holding record button tap the flash button in the following sequence:1-3-2-3.Relese the
record button.
7) All LEDS should light indicating all program have been erases.
8) Press and hold RECORD & REX EXIT to exit the mode.
Warning :This will reset the controller to its factory defaults. This will erase all program and setting.
NOTES :You must be in record mode to reset the controller.
The LED over the record button will light, indicating the Record mode operation.
ENTERING PROGRAM MODE (RECORD ENABLE)
1. While holding the RECORD button, tap the Flash buttons 1-5-6-8 in sequence.
2. Release the RECORD button. The Record LED light up.
A scene is a static lighting state. Scenes are stored in the temporary memory, until they are
transferred to one of the playback faders. You may create a single scene or a succession of up to 999
steps per Scene.
1) Record enable.
2) Select the 1-24 Single mode by tapping the Mode Select button. This will give you control of all 24 channels of the first page.
3) Compose a look by moving the FADERS.(Changes in fixture attribute such as colors and gobos, or simply dimmer values).
4) Press Record to save the look into the temporary memory.
5) Repeat steps 2 ~ 4 until you have your desired scene.
6) Adjust the Speed and Fade sliders to achieve the desired amount of time a scene will be held in a chase (speed) and the
amount of time allowed for the fixtures to move from one scene to the next (fade).
7) Select a Scene master to store your scene. Tap the Page button to select a page (1-4).
8) Press and hold the Record button & tap the Flash button for the scene that you wish to store it to. All LEDs will flash indicating
the scene has been programmed into memory.
9) You can continue programming or exit. To exit program mode, press and hold the Record button & tap the Rec Exit button.
Deselect Blackout if LED is lit.
If you just wish to create a static look, then you must create a scene composed of only 1 step.
There are 999 steps available in every scene.
EDI T ENABLE
1) Record enable.
2)Use the Page button to select the page the program you wish to edit is on.
3)Tap the Mode Select button to select Chase ..Scenes.
4)Press and hold the Edit button & tap the Flash button (13-24) of the Scene you wish to edit.
5)Release the Edit button. The relevant Scene Led should light, indicating you are in Edit mode.
Notes
When the EDIT mode is entered properly, the display will read EDITING.
This mode is displayed here for only the initiation of EDIT mode. Please see the following sections on the uses of this
mode in detail.
ERASE A PROGRAM
ACTION
1) Record enable.
2) Use the Page button to select the page the Scene you wish to erase is on.
3)Press and hold Record button & tap the Flash button(13-24) twice of Scene you wish to erase
4)Release Record button and all LEDs should on to indicate the program is erased
ERASE ALL SCENES
ACTION
RECORD CLEAR
ACTION
1) Record enable.
2) Record a scene with 1 or more steps.
DMX 512 CONTROLLER SERIES