AVSL 154.095 DM-X24 - Manual (Page 12)

11/19 USER MANUAL
5.Playback
PLAYING A SCENE
A Scene can contain 1000steps.Thrm steps and scenes interchangeably.
Action
1) Tap the ode select button to select Chase SCENE MODE.
2) Tap the page to select the correct page the program you wish to run is located.
3) Push master Slider B to its maximum position(fully down)
4) Move the desired Channel slider( 13-24) to its maximum and Scene will fade in depending
upon current fade time.
5) Move the channel Slider to adjust the output of the current program.
Notes: The current mode is indicated by the 3 LEDS. Red is the Chase scene . Yellow is 2-
scene preset a/b ,And, Green is 1-24 single mode.
You may press and down the relevant Flash button Scene to trigger the button Momentarily.
This controller uses the Channel Faders and Flash buttons for multiple uses. In
this occurrence, Channel faders 13-24 are used playing back of scenes already recorded.
This is only when the controller is the Chase scene mode. In this instance, Master Fader A
will control the manual fader controls, whish Master Fader B will control the Scenes being
played back.
Channel
PLAYING A SCENE TO AUDIO TRIGGERING
Action
1) Select your as Scene as described in the above section.
2) Tap the Audio button until LED lights, indicating AUDIO mode is active.
3) Use the Audio Level slider to adjust the sensitivity.
4) To return to normal mode, tap the Audio button a second time, causing its LED to go out. AUDIO
mode is disengaged.
NOTES: This is the process of using the built-in microphone, or using the audio jack on the
controller to use an alternative audio source for triggering of Scenes.
DMX 512 CONTROLLER SERIES