Armasight DAS01XX25MCSTAN MCS Miniature Collimating Sight - Manual (Page 6)

6
3. OpERATING pROCEDURE
ON/AUTO bATTERY CHECK: Pressing and releasing the right button will
turn the sight on in auto-brightness mode. If the battery has less than 10%
power remaining, the reticle will blink after the sight powers on. If the
reticle blinks, the battery should be replaced. The battery condition can
be checked at any time by powering off and then immediately powering
on the unit.
OFF: While the sight is on, pressing and releasing the right button will turn
the sight off.
AUTO-bRIGHTNESS OvERRIDE: Pressing and holding the right button for
two (2) seconds will place the reticle in MAX brightness mode. This mode
can be used to override the auto-brightness function, in case the photo
sensor becomes damaged or blocked. To return to auto-brightness mode,
press and hold the right button for two (2) seconds.
CHANGING bETWEEN RETICLE pATTERNS: Pressing and releasing the left
switch will toggle the reticle pattern from a 3.5 MOA dot to a 20 MOA ring.
The 20 MOA ring allows for faster target acquisition in CQB (close-quarters
battle) conditions, while the 3.5 MOA dot allows for greater precision when
shooting at longer-range targets.
(RIghT) On/Off &
MAx BRIghTneSS
WIndAge
(LefT) dOT/RIng &
nIghT vISIOn
eLevATIOn
BATTeRY
COMPARTMenT
Figure 2: MCS
3.5 MOA
3 MOA
20 MOA
CIRCLE
Ø 3.5 MOA
DOT
Figure 3: Reticle patterns