Armasight DAS01XX25MCSTAN MCS Miniature Collimating Sight - Manual (Page 5)

5
1.4 LOCATION OF MAJOR COMpONENTS
2. SAFETY, CARE AND HANDLING
WEApON SAFETY: Prior to mounting the MCS on your weapon, verify that
the weapon is cleared. If you are not sure how to clear your weapon, please
see the accompanying operator’s manual for the weapon platform that
you using to mount the sight.
FCC COMpLIANCE: The MCS complies with Part 15 of the FCC Rules. Op-
eration is subject to the following conditions: (1) this device may not cause
harmful interference; and, (2) this device must accept any interference re-
ceived, including interference that may cause undesired operation.
When a sudden increase in resistance is felt in the elevation or windage
adjustment shafts, the end of the adjustment range has been reached. Do
not turn the adjustments any farther or serious damage may occur to
the sight.
Never clean the glass surface with a dry cloth or paper towel; always damp-
en the glass surfaces prior to cleaning.
All moving parts of the sight are permanently lubricated. Do not try to lu-
bricate them.
Do not use deteriorated or corroded batteries. Inspect batteries for rips,
tears, dents, or cuts in their casing. If you find any leakage on the battery, it
could adversely affect operation of the sight.
LenS
COveR
IMAge
WIndOW
PROTeCTIve
COveR
PhOTO SenSOR
WIndAge
AdjUSTMenT
RIghT
BUTTOn
LefT
BUTTOn
BATTeRY
hOLdeR
MOUnTIng
SCReW
eLevATIOn
AdjUSTMenT
Figure 1. MCS Components