Armasight DAS01XX25MCSTAN MCS Miniature Collimating Sight - Manual (Page 11)

11
7. TROUbLESHOOTING
Common problems that may occur with your MCS or the detection and
viewing tests, as well as actions you can take to correct them, are listed in
the Troubleshooting Table, below. This table does not list all of the malfunc-
tions that may occur with your device. If you experience a malfunction that
is not listed on this table, please contact Armasight or your MCS retailer
NOTE:
Before you use this table, be sure that you have performed all normal
operational, safety, care and handling checks and procedures. If
you experience a malfunction that is not listed in this table, notify
Armasight or your MCS retailer.
TAbLE 1. TROUbLESHOOTING GUIDE
pRObLEM pOSSIbLE CAUSE ACTION
The sight will not
power up.
The batteries are not
installed properly.
Ensure that the battery has been
inserted properly according to the
diagram on the side of the battery
compartment.
Damaged or low batteries. Replace the battery with a new, un-
used battery that is fully charged.
If these actions fail, submit the device to the vendor for maintenance.
The reticle is
fuzzy/ has a ‘halo’
effect.
If the sight is in maximum
brightness mode and is
being viewed against
a dark background,
undesired reflections may
be seen due to the nature
of the technology. Max
brightness mode is not
intended for use in poorly
lit conditions, as it may
obscure the target.
Ensure that the sight is in auto-bright-
ness mode. Turn the sight off, and
then back on, or press and hold the
right button for 2 seconds.
If these actions fail, submit the device to the vendor for maintenance.