Armasight NRWVULCAN439DB1 Vulcan 4.5X Gen3 Bravo MG - Compact Professional 4.5x Night Vision Rifle Scope - Manual (Page 34)

34
4.4.3 BATTERY REMOVAL AND REPLACEMENT
Refer to Part 3.1.1 for Vulcan and IR850 battery installation procedures.
Replace the remote control batteries as follows:
1. Using a screwdriver, unscrew the four screws (A, Figure 4-6) that affix the cover to the bottom of the
unit. Remove the cover.
2. Replace the battery with new one (CR2032, 3V). Align the polarity (plus and minus) symbols on the
battery with those on the battery compartment.
3. Replace the cover and retighten the screws (A).
FIGURE 4-6. ADVANCED WIRELESS REMOTE CONTROL. BATTERY INSTALLATION
a
4.5 RETURN INSTRUCTIONS
For service, repair or replacement, please email [email protected].
To assist the Service Representative (SR) with determining whether or not an item is repairable, please
provide the following information:
1. Serial Number of the defective item. This is engraved on the body of the device.
2. Thorough description of the malfunction, defect or damage.
3. An explanation of how the malfunction, defect or damage occurred, if known.
If the SR determines that the item is under warranty or should be returned for repair, a Return Material
Authorization number (RMA#) will be provided. RMA can be obtained via e-mail to
[email protected], via phone by calling Armasight Customer Service at (888) 959-2259 Ext. 2, or
via fax at (888) 959-2260.
When returning the Vulcan for service or repair, the following procedures should be done to prevent
any additional damage:
1. Verify that the Vulcan is free of all contaminants, such as dirt or any other foreign material.
2. Remove the battery.
3. Place the cap over the objective lens.
4. Screw the cap onto the output lens.
5. Place the Vulcan and its accessories into the shipping case. Place the Vulcan and a copy of the test re-
port (or detailed description of the failure) in a suitable packing/ shipping container. Mark the pack-
age with the RMA#. Ship using a fast, traceable service. Shipping must be prepaid by the Customer.