Xoro HRT 8300 - Manual (Page 52)

ENG 12 HRT 8300
Engl
ish
Connection
General Information:
•
Assure that the device is switched off and unplugged.
• Read the manual of your TV and note the safety instructions.
•
Please establish an accurate connection.
Connection to a TV and an antenna
The connection of the HRT8300 to an antenna and a TV is illustrated below. There are many
alternative ways of connecting a TV. Please read the manual of your TV to find the available jacks.
If there are multiple jacks available, please choose the one with best quality according to the table
below.
Notes:
The receiver can power an active antenna with 5V. It is described on page 31 how to activate this
voltage.
To a TV and an antenna
Jack Signal Notes Quality
HDMI Picture and
sound
Resolution setup: see page 32, HD resolution is not
available, if „SCART RGB“ is selected at the setting
of Video output ММММ
YPbPr Only picture Resolution setup: see page 32, requires separate
cable for sound (Audio out), not available, if
„SCART RGB“ is selected at the setting of Video
output ÌÌÌ
SCART Picture and
sound
In the factory default, RGB signal output is not
active. See page 32. ÌÌ
CVBS Only picture requires separate cable for sound (Audio out) М