Asus Sabertooth X58 - Manual (Page 71)

ASUS SABERTOOTH X58 3-13
Chapter 3
The configuration options for the following sub-items vary depending on the DIMMs you
install on the motherboard.
DRAM O.C. Profile [DDR3-1805MHz]
This item appears only when you set the Ai Overclock Tuner item to [D.O.C.P.] and allows
you to select a DRAM O.C. profile, which applies different settings to DRAM frequency,
DRAM timing and DRAM voltage. Configuration options: [DDR3-1805MHz] [DDR3-2006MHz]
eXtreme Memory Profile [Disabled]
This item appears only when you set the Ai Overclock Tuner item to [X.M.P.] and allows you
to select the X.M.P. mode supported by your memory module.
[Disabled]
You are not allowed to select the memory profile.
[High Performance] Allows your memory to work in high performance.
[High Frequency] Allows your memory to work in high frequency.
To obtain the best performance of the X.M.P. DIMM or 1600MHz DIMM, install only one
DIMM on each memory channel.
3.5.2 CPU Ratio Setting [Auto]
Allows you to set the ratio between the CPU Core Clock and the BCLK Frequency. Use <+>
and <-> keys to adjust the ratio. The valid value ranges vary according to your CPU model.
3.5.3 Intel(R) SpeedStep(TM) Tech [Enabled]
[Enabled] The CPU speed is controlled by the operating system.
[Disabled] The CPU runs at its default speed.
3.5.4 Intel(R) TurboMode Tech [Enabled]
[Enabled] Allows processor cores to run faster than marked frequency in specific
condition.
[Disabled] Disables this function.
3.5.5 Xtreme Phase Full Power Mode [Auto]
[Auto] Automatic configuration.
[Enabled] Enables Full Power Mode to ensure the best CPU overclocking
performance.
The following two items appear only when you set the Ai Overclock Tuner item to [Manual],
[D.O.C.P.] or [X.M.P.].
3.5.6 BCLK Frequency [XXX]
Allows you to adjust the CPU operating frequency to enhance the system performance. Use
the <+> and <-> keys to adjust the value. You can also key in the desired value using the
numeric keypad. The values range from 100 to 500.