Asus ME99-VM - Manual (Page 25)

ASUS ME-99VM User’s Manual 25
3. HARDWARE SETUP
Connectors
3. H/W SETUP
11) Wake-On-LAN Connector (3-pin WOL_CON)
These connector connects to LAN cards with a Wake-On-LAN output, such as
the ASUS PCI-L101 Ethernet card (see 7.1 ASUS PCI-L101 Fast Ethernet Card).
The connector powers up the system when a wakeup packet or signal is received
through the LAN card.
IMPORTANT: This feature requires that Wake On LAN is set to Enabled (see
4.5.1 Power Up Control) and that your system has an ATX power supply with at
least 720mA +5V standby power.
ME-99VM Wake-On-LAN Connector
IMPORTANT: Requires an ATX power
supply with at least 720mA +5Volt
standby power.
+5 Volt Standby
PME
Ground
12) Chassis and CPU Fan Connectors (3-pin CHA_, CPU_FAN)
These connectors support cooling fans of 500mA (6 Watts) or less. Orientate the
fans so that the heat sink fins allow airflow to go across the onboard heat sink(s)
instead of the expansion slots. Depending on the fan manufacturer, the wiring
and plug may be different. The red wire should be positive, while the black
should be ground. Connect the fan’s plug to the board taking into consideration
the polarity of the connector. NOTE: The “Rotation” signal is to be used only
by a specially designed fan with rotation signal.
WARNING! The CPU and/or motherboard will overheat if there is no airflow
across the CPU and onboard heatsinks. Damage may occur to the motherboard
and/or the CPU fan if these pins are incorrectly used. These are not jumpers,
do not place jumper caps over these pins.
ME-99VM Cooling Fan Connectors
CPU Fan Power
Rotation
+12V
Ground
Chassis Fan Power
Rotation
+12V
Ground