Asus M2N68-VM - Manual (Page 38)

1-26 Chapter 1: Product introduction
4. Serial ATA connectors (7-pin SATA1, SATA2, SATA3)
These connectors are for the Serial ATA signal cables for Serial ATA
3Gb/s hard disk and optical disk drives. The Serial ATA 3Gb/s is backward
compatible with Serial ATA 1.5Gb/s specification. The data transfer rate of the
Serial ATA 3Gb/s is faster than the standard parallel ATA with 133 MB/s (Ultra
DMA133).
If you install Serial ATA hard disk drives, you can create a RAID 0, RAID 1,
RAID 5, RAID 10, and JBOD configuration through the onboard controllers
and one ESATA.
Install the Windows ® XP Service Pack 1 before using Serial ATA.
• For detailed instructions on how to configure RAID 0, RAID 1, RAID 5, and
RAID 10, and JBOD, refer to the RAID manual in the support CD.
• If you intend to create a Serial ATA RAID set using these connectors, set
the SATA Mode select item in the BIOS to [RAID Mode]. See the
page 2-16 for details.
M2N68-VM
M2N68-VM SATA Connectors
Serial ATA hard disk drive connection
Connector Color Setting Use
SATA1 Red Master Boot
SATA2 Red Slave Data
SATA3 Red Slave Data