Asus SP97-V - Manual (Page 18)

18 ASUS SP97 / SP97-V User’s Manual
(Jumpers)
III. INST
ALLA
TION
III. INSTALLATION
4. Voltage Regulator Output Selection (VID0, 1, 2)
These jumpers set the voltage supplied to the CPU.
Intel Pentium (P54C)
(75MHz-200MHz) Pentium MMX (P55C)
(150MHz-233MHz) AMD-K6
(PR166 and faster) AMD-K5
(PR75-PR133) IBM/Cyrix 6x86(MX)
(PR166 and faster) IBM/Cyrix 6x86(M1)
(PR166 and faster)
WARNING! Because CPU designs change rapidly, the table below is only
intended as a simple guideline and thus may not be true for your CPU. Always
refer to the CPU documentation for your CPU’s voltage and then set the ap-
propriate VID jumpers according to the illustration below.
Manufacturer CPU Type Single Plane Dual Plane VID2 VID1 VID0
Intel P54C/P54CS 3.5V(VRE) ---- [2-3] [2-3] [1-2]
AMD K5 3.5V(VRE) ---- [2-3] [2-3] [1-2]
IBM/Cyrix 6x86 3.5V(VRE) ---- [2-3] [2-3] [1-2]
Intel P54C/P54CS 3.4V(STD) ---- [2-3] [2-3] [2-3]
AMD K5 3.4V(STD) ---- [2-3] [2-3] [2-3]
AMD (.35micron) K6-PR233 ---- 3.2V(Dual) [1-2] [2-3] [2-3]
AMD (.35micron) K6-166,200 ---- 2.9V(Dual) [2-3] [2-3] [1-2]
IBM/Cyrix 6x86MX ---- 2.9V(Dual) [2-3] [2-3] [1-2]
Intel P55C-MMX ---- 2.8V(Dual) [2-3] [2-3] [2-3]
AMD (.25micron) K6-233,266,300 ---- 2.1V(Dual) [2-3] [2-3] [1-2]
CPU Vcore Voltage ID Selection
R
Note: Auto-voltage detection regulators allow some
jumper settings to be the same for two voltages.
1 2 3 1 2 3 1 2 3 1 2 3 1 2 3 1 2 3
VID2
VID1
VID0
Dual Plane CPU Single Plane CPU
3.2 Volts 2.1 Volts 2.9 Volts 2.8 Volts 3.5 Volts
(VRE) 3.4 Volts
(STD)