Asus M4A88T-M/USB3 - Manual (Page 37)

3. Serial ATA connectors (7-pin SATA1-6)
These connectors are for the Serial ATA signal cables for Serial ATA 3Gb/s hard disk
and optical disk drives. The Serial ATA 3Gb/s is backward compatible with Serial ATA
1.5Gb/s specification. The data transfer rate of the Serial ATA 3Gb/s is faster than the
standard parallel ATA with 133 MB/s (Ultra DMA133). If you install Serial ATA hard disk
drives, you can create RAID 0, RAID 1, RAID 0+1, and JBOD configurations through
the onboard SB710 chipset.
• Install the Windows ® XP Service Pack 1 or later versions before using Serial ATA.
• If you intend to create a Serial ATA RAID set using these connectors, set the SATA
Port1-Port4 and SATA Port5-Port6 items in the BIOS to [RAID]. See 2.3.4 SATA
Configuration for details.
• The motherboard does not provide a floppy disk drive connector. You could use a USB
floppy disk drive when installing Windows ® XP operating system on a hard disk drive
that includes a RAID/AHCI set.
• Due to Windows ® XP limitation, Windows ® XP may not recognize the USB floppy disk
drive.
• For more details on RAID/AHCI, refer to the RAID/AHCI Supplementary Guide included
in the folder named Manual in the support DVD.
SATA5
GND
RSATA_TXP5 RSATA_TXN
5
GND
RSATA_RXP5 RSATA_RXN
5
GND
SATA6
GND
RSATA_TXP6 RSATA_TXN
6
GND
RSATA_RXP6 RSATA_RXN
6
GND
SATA4
GND
RSATA_TXP4 RSATA_TXN
4
GND
RSATA_RXP4 RSATA_RXN
4
GND
SATA2
GND RSATA_RXN
2
RSATA_RXP2 GND RSATA_TXN
2
RSATA_TXP2 GND
SATA3
GND RSATA_RXN
3
RSATA_RXP3 GND RSATA_TXN
3
RSATA_TXP3 GND
SATA1
GND RSATA_RXN
1
RSATA_RXP1 GND RSATA_TXN
1
RSATA_TXP1 GND M4A88T-M
M4A88T-M SATA connectors
ASUS M4A88T-M 1-25