Asus H61M-D - Manual (Page 14)

ASUS H61M-D 1-7
1.4 System memory
1.4.1 Overview
This motherboard comes with two Double Data Rate 3 (DDR3) Dual Inline Memory Module
(DIMM) sockets. A DDR3 module is notched differently from a DDR or DDR2 module. DO
NOT install a DDR or DDR2 memory module to the DDR3 slot.
According to Intel ® CPU spec, DIMM voltage below 1.65V is recommended to protect the
CPU.
Channel Sockets
Channel A DIMM_A1
Channel B DIMM_B1
H61M-D
H61M-D 240-pin DDR3 DIMM sockets
DIMM_A1 DIMM_B1
1.4.2 Memory configurations
You may install 1GB, 2GB, 4GB, and 8GB unbuffered non-ECC DDR3 DIMMs into the DIMM
sockets.
• You may install varying memory sizes in Channel A and Channel B. The system maps
the total size of the lower-sized channel for the dual-channel configuration. Any excess
memory from the higher-sized channel is then mapped for single-channel operation.
• DDR3 1600MHz and higher memory frequency is supported by Intel ® 3rd generation
processors.
• Due to the CPU behavior, DDR3 2133 /1866 MHz memory modules will run at DDR3
2000 / 1800 MHz frequency.
• Always install DIMMs with the same CAS latency. For optimal compatibility, we
recommend that you install memory modules of the same version or date code (D/C)
from the same vendor. Check with the retailer to get the correct memory modules.
• Due to the memory address limitation on 32-bit Windows ® OS, when you install 4GB
or more memory on the motherboard, the actual usable memory for the OS can be
about 3GB or less. For effective use of memory, we recommend that you do any of the
following:
- Use a maximum of 3GB system memory if you are using a 32-bit Windows ® OS.
- Install a 64-bit Windows ® OS if you want to install 4GB or more on the
motherboard.
• This motherboard does not support DIMMs made up of 512Mb (64MB) chips or less.