beautypg.com

Asus P5KPL-AM IN/ROEM/SI User Manual

Page 20

background image

2.

IDE connector (40-1 pin PRI_IDE)
The onboard IDE connector is for the Ultra DMA 100/66/33 signal cable. There are

three connectors on each Ultra DMA 100/66/33 signal cable: blue, black, and gray.

Connect the blue connector to the motherboard’s IDE connector, then select one of the

following modes to configure your device.

Driver Jumper setting

Mode of device(s)

Cable connector

Single device

Cable-Selected or Master

-

Black

Two devices

Cable-Select

Master

Black

Slave

Gray

Master

Master

Black or gray

Slave

Slave

• Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA

cable connector. This prevents incorrect insertion when you connect the IDE cable.

• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.

If any device jumper is set as

“Cable-Select,” ensure that all other

device jumpers have the same

setting.

3.

USB connectors (10-1 pin USB56, USB78)
These connectors are for USB 2.0 ports. Connect the USB module cable to any of

these connectors, then install the module to a slot opening at the back of the system

chassis. These USB connectors comply with USB 2.0 specification that supports up to

480 Mbps connection speed.

Never connect a 1394

cable to the USB

connectors. Doing so will

damage the motherboard!

The USB module cable

is purchased separately.

1-11

ASUS P5KPL-AM IN/ROEM/SI