Asus Vintage-PH1 - Manual (Page 39)

2 - 2 1 2 - 2 1 2 - 2 1 2 - 2 1 2 - 2 1 A S U S V i n t a g e - P H 1 A S U S V i n t a g e - P H 1 A S U S V i n t a g e - P H 1 A S U S V i n t a g e - P H 1 A S U S V i n t a g e - P H 1
5. Connect a power cable from
the power supply to the
power connector at the back
of the HDD. Use the cable with
the white connector.
6. Connect the IDE hard disk
ribbon cable to the IDE
interface at the back of the
HDD, matching the red stripe
on the cable with Pin 1 on the
IDE interface.
R e d s t r i p e t o P i n 1 R e d s t r i p e t o P i n 1 R e d s t r i p e t o P i n 1 R e d s t r i p e t o P i n 1 R e d s t r i p e t o P i n 1
I D E r i b b o n c a b l e I D E r i b b o n c a b l e I D E r i b b o n c a b l e I D E r i b b o n c a b l e I D E r i b b o n c a b l e P o w e r c a b l e P o w e r c a b l e P o w e r c a b l e P o w e r c a b l e P o w e r c a b l e
7. Connect the other end of the
IDE ribbon cable to the primary
IDE connector on the
motherboard.
P r i m a r y I D E c o n n e c t o r P r i m a r y I D E c o n n e c t o r P r i m a r y I D E c o n n e c t o r P r i m a r y I D E c o n n e c t o r P r i m a r y I D E c o n n e c t o r