Asus P5N32-SLI Premium - Manual (Page 92)

- Chapter : BIOS setup
4.4.2 AI NET2
Select Menu
Item Specific Help
Enable or disable LAN
cable check during POST.
AI NET2
POST Check LAN Cable [Disabled]
POST Check LAN2 Cable [Disabled]
Pair Status Length
LAN1(1-2) Open 0.0M
LAN1(3-6) Open 0.0M 3-6) Open 0.0M
LAN1(4-5) Open 0.0M 4-5) Open 0.0M
LAN1(7-8) Open 0.0M 7-8) Open 0.0M
LAN2(1-2) Open 0.0M 1-2) Open 0.0M
LAN2(3-6) Open 0.0M 3-6) Open 0.0M
LAN2(4-5) Open 0.0M 4-5) Open 0.0M
LAN2(7-8) Open 0.0M
Phoenix-Award BIOS CMOS Setup Utility
Advanced
F1:Help ↑↓ : Select Item -/�: Change Value F5: Setup Defaults
ESC: Exit →← : Select Menu Enter: Select SubMenu F10: Save and Exit
POST Check LAN Cable [Disabled]
POST Check LAN2 Cable [Disabled]
Allows you to enable or disable LAN cable check during POST. When enabled, the
menu reports the cable faults or shorts, and displays the point (length) where the
fault or short is detected. Configuration options: [Disabled] [Enabled]
4.4.3 PEG Link Mode
Select Menu
Item Specific Help
Press to
Enable/Disable PCI
Express graphics card
over-clocking by
accelerating PCI-Ex
connecting mode and
determine the speed
level on it.
PEG Link Mode
PEG Link Mode [Auto]
Phoenix-Award BIOS CMOS Setup Utility
Advanced
PEG Link Mode [Auto]
Sets the PCI Express graphics link mode. Setting this item to [Auto] allows the
motherboard to automatically adjust the PCI Express graphics link mode to the
correct frequency based on the system configuration. Three additional settings
are available for overclocking the PEG Link Mode. Configuration options: [Auto]
[Disabled] [Normal] [Fast] [Faster]