Asus AP1710-E1 - Manual (Page 62)

C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p 2 - 3 8 2 - 3 8 2 - 3 8 2 - 3 8 2 - 3 8
2.10 Removable components
You may need to remove previously installed system components when
installing or removing system devices, or when you need to replace
defective components. This section tells how to remove the following
components:
1. Air duct
2. Chassis fan
3. HDD blowers
4. SATA/SCSI backplanes
5. Floppy disk drive module
6. Front I/O board
7. Chassis footpads and roller
wheels
8. Power supply
2.10.1 2.10.1 2.10.1 2.10.1 2.10.1 Air duct Air duct Air duct Air duct Air duct
The barebone server system features an air duct that provides cool air
from the outside through the chassis side cover vent for the system to
maintain optimum thermal performance . The HDD blowers circulate cool air
within the system.
To uninstall the air duct:
1. Press, then slide down the blue
tab in the middle of the top
lock.
B
A
2. Simultaneously push up the side
locks at the lower part of the air
duct.
3. Carefully pull out the air duct
out of the chassis, and set it
aside.