Asus P5S-VM - Manual (Page 31)

ASUS P5S-VM User’s Manual 31
III. HARDWARE SETUP
14. ATX Power Switch/Soft Power Switch Lead (PWR, 2 pins)
The system power can be controlled by a momentary switch connected to this
lead. Pushing the button once will switch the system between ON and SLEEP.
Pushing the switch while in the ON mode for more than 4 seconds will turn the
system off. The system power LED shows the status of the system’s power.
15. IDE Activity LED Lead (IDELED, 2 pins)
This connector supplies power to the cabinet’s IDE activity LED. Read and
write activity by devices connected to the Primary or Secondary IDE connectors
will cause the LED to light up.
16. System Power LED Lead (PLED, 3 pins)
This 3-pin connector connects the system power LED, which lights when the
system is powered on and blinks when it is in sleep mode.
17. Reset Switch Lead (RESET, 2 pins)
This 2-pin connector connects to the case-mounted reset switch for rebooting
your computer without having to turn off your power switch This is a preferred
method of rebooting in order to prolong the life of the system’s power supply.
18. Message LED Lead (MLED, 2 pins)
This indicates whether a message has been received from a fax/modem. The
LED will remain lit when there is no signal and blink when there is data transfer
or messages waiting in the inbox. This function requires ACPI OS support.
19. Keyboard Lock Switch Lead (KEYLOCK, 2 pins)
This 2-pin connector connects to the case-mounted key switch to allow key-
board locking.
20. Speaker Connector (SPEAKER, 4 pins)
This 4-pin connector connects to the case-mounted speaker.
P5S-VM System Panel Connectors
ATX Power Switch
requires an ATX power
supply, optional ATX to
AT power connector
adapter, and momentary
switch button
0 1
Speaker
Connector
Reset SW
ATX Power
Switch
Keyboard Lock
Message LED
IDE LED
Power LED
KEYLOCK GND +5V SPEAKER
GND GND
GND GND GND +5V
IDELED
GND
PLED
+5V
PWRSWT
RESET
Connectors
III. H/W SETUP