Asus F2A55-M LK PLUS - Manual (Page 37)

3. Serial ATA 3.0 Gb/s connectors (7-pin SATA3G 1~6)
These connectors are for the Serial ATA 3.0 Gb/s signal cables for Serial ATA hard
disk drives and optical disc drives. If you installed Serial ATA hard disk drives, you can
create a RAID 0, RAID 1, or RAID 10 configuration through the onboard controller.
• These connectors are set to AHCI mode by default. If you intend to create a Serial ATA
RAID set using these connectors, set the type of the SATA connectors in the BIOS to
[RAID]. See section 2.5.2 SATA Configuration for details.
• You must install Windows ® XP Service Pack 3 or later version before using Serial
ATA hard disk drives. The Serial ATA RAID feature is available only if you are using
Windows ® XP SP3 or later version.
• When using hot-plug and NCQ, set the type of the SATA connectors in the BIOS to
[AHCI]. See section 2.5.2 SATA Configuration for details.
GND
RSATA_RXP1 RSATA_RXN1
GND
RSATA_TXN1 RSATA_TXP1
GND
SATA3G_1
GND
RSATA_RXP2 RSATA_RXN2
GND
RSATA_TXN2 RSATA_TXP2
GND
SATA3G_2
GND
RSATA_RXP3 RSATA_RXN3
GND
RSATA_TXN3 RSATA_TXP3
GND
SATA3G_3
GND
RSATA_RXP4 RSATA_RXN4
GND
RSATA_TXN4 RSATA_TXP4
GND
SATA3G_4
GND
RSATA_RXP5
RSATA_RXN5
GND
RSATA_TXN5
RSATA_TXP5
GND
SATA3G_5
GND
RSATA_RXP6
RSATA_RXN6
GND
RSATA_TXN6
RSATA_TXP6
GND
SATA3G_6
F2A55-M LK PLUS SATA 3.0Gb/s connectors
F2A55-M LK PLUS
4. LPT connector (26-1 pin LPT)
The LPT (Line Printing Terminal) connector supports devices such as a printer. LPT
standardizes as IEEE 1284, which is the parallel port interface on IBM PC-compatible
computers.
F2A55-M LK PLUS
F2A55-M LK PLUS LPT connector
PIN 1
LPT
STB# PD0 PD1 PD2 PD3 PD4 PD5 PD6 PD7 ACK# BUSY
PE
SLCT
AFD ERR# INIT# SLIN# GND GND GND GND GND GND GND GND
ASUS F2A55-M LK Series 1-25