Asus M2N-X - Manual (Page 65)

ASUS M2N-X 2-2
Memclock Mode [Auto]
Select the DRAM Frequency programming method. If Auto, the DRAM
speed will be based on SPDs. If Limit, the DRAM speed will not exceed
the specified value. If Manual, the DRAM specified will be programmed
regardless.
Configuration options: [Auto] [Limit] [Manual]
CAS Latency (CL) [Auto]
Sets the CAS latency timing.
Configuration options: [Auto] [3.0] [4.0] [5.0] [6.0]
TRCD [Auto]
Sets the RAS-to-CAS delay timing.
Configuration options: [Auto] [3 CLK] [4 CLK] [5 CLK] [6 CLK]
TRP [Auto]
Sets the row-precharge delay timing.
Configuration options: [Auto] [3 CLK] [4 CLK] [5 CLK] [6 CLK]
TRAS [Auto]
Sets the row-active delay timing.
Configuration options: [Auto] [5 CLK] [6 CLK] ~ [18 CLK]
Command Timing (2T mode) [Auto]
Sets the command timing. (per clock unit)
Configuration options: [Auto] [1T] [2T]
Memory Configuration
Memory Setting: 266MHz-4.0-4-4-12-2T
Memclock Mode [Auto]
CAS Latency (CL) [Auto]
TRCD [Auto]
TRP [Auto]
TRAS [Auto]
Command Timing (2T mode) [Auto]
MCT Timing Mode [Auto]
Bank Interleaving [Disabled]
Enable Clock to ALL DIMMs [Disabled]
MemCLK Tristate C3/ATLVID [Disabled]
DQS Signal Training Control [Enabled]
Memory Hole Remapping [Enabled]
Memory Configuration