Asus WL-330g - Manual (Page 20)

20 ASUS Pocket Wireless Access Point (WL-330g)
English
Replacing the cable connections of other devices
You can also use the WL-330g to replace your Xbox, PlayStation ® 2, or set-top
box network cable connection.
To do this:
1. Switch the WL-330g to Ethernet adapter mode using the mode switch.
(Default SSID: ANY)
2. Place the WL-330g nearest the AP you wish to connect, then turn on the device.
3. Connect one end of the supplied RJ-45 cable to the Ethernet port of the
device and the other end to the Xbox, PlayStation ® 2, or set-top box
Ethernet port.
4. Set the IP address of the Xbox, PlayStation ® 2, or set-top box to establish
connection to the local network. Verify your connection.
Make sure the WL-330g MAC cloning feature is enabled when using the
device in this setup. Use the Wireless Setting Utility to enable MAC
cloning. Refer to the User Guide in the support CD for details.
Sharing Internet access with other computers
Refer to the typical network configuration and table below for information on
sharing an Internet access with other computers in your office or home network.
1 xDSL – ADSL (Asymmetric Digital Subscriber Line) or DSL (Digital Subscriber Line)
2 PPPoE – Point-to-Point over Ethernet
3 DHCP – Dynamic Host Configuration Protocol
xDSL 1 with dynamic IP ISP automatically assigns Depends on the Internet Service
(PPPoE 2 account) the IP (using PPPoE dial-up) Provider (ISP)
xDSL with static IP to the provided static IP Depends on the Internet Service
Provider (ISP)
xDSL/Cable with a router No need; the DHCP server Depends on the DHCP server,
and enable DHCP 3 server automatically assigns the IP usually about 253
If your Internet
connection is
Then set the IP of
other computer(s)
Number of allowed
Internet connections
Use the mode switch to set the WL-330g to AP mode before sharing an
Internet connection with other computers in your network.
Wireless computer Internet ADSL/Cable modem WL-330g