Asus P2Z-VM - Manual (Page 15)

ASUS P2Z-VM User’s Manual 15
III. HARDWARE SETUP
III. H/W SETUP
Motherboard Settings
2. VGA Setting (VGAEN)
The VGAEN jumper allows you to enable or disable the onboard VGA. Disable the
onboard VGA if you are using a VGA card on the expansion slot.
P2Z-VM VGA Setting
VGAEN
R
P2Z-VM
Disable Enable
(Default)
1 2 3 1 2 3
3. Keyboard Power (Wake) Up (KB_WAK)
This allows you to disable or enable the keyboard power up function. Set this
jumper to Enable if you wish to use your keyboard (by pressing any key or the
spacebar, depending on your motherboard) to power up your computer. This
feature requires an ATX power supply that can supply at least 300mA on the
+5VSB lead. The default is set to Disable because not all computers have the
appropriate ATX power supply. Your computer will not power ON if you set this
to Enable and do not have the appropriate ATX power supply.
WARNING!
This jumper setting must coincide with the BIOS setting (see “Power Up By
Keyboard” in the Power Management Setup of BIOS SETUP) or else conflicts
will occur.
Setting KB WAK
Disable [1-2] (default)
Enable [2-3]
P2Z-VM Keyboard Power (Wake) Up
Disable
(Default)
KB_WAK
Enable
1 2 3 1 2 3
R
P2Z-VM
Setting VGAEN
Enable [1-2] (default)
Disable [2-3]