Asus PXL-S30R - Manual (Page 25)

ASUS PXL-S30R 2-13
Adding or deleting hot spares
You may configure one disk as a global hot spare to protect critical data on the IM
volume(s). You may create the hot spare disk at the same time you create the IM
volume. Refer to this section when adding a hot spare disk on an existing volume.
If a disk on an IM volume fails, the utility automatically rebuilds the failed disk
data on the hot spare. When the failed disk is replaced, the utility assigns the
replacement as the new hot spare.
To create a hot spare:
1. Follow steps 1~2 of the section Viewing volume properties.
2. From the screen, press to select .
3. Use the arrow key to select the disk you would like to configure as hot spare,
then move the cursor to the Hot Spare column. Press <+> or <-> and the
Hot Spare column field now shows Yes.
Esc=Abort/Exit ArrowKeys=Select Item -/+ =Change [Item]
Home/End =Select Item Enter=Execute
F2 =Menu
LSI Logic MPT SCSI Setup Utility Version MPTBIOS-IME-5.10.03
RAID Properties Array: IM SCSI ID: 8 Size(MB): 70008
SCSI Device Identifier Array Hot Status Predict Size
ID Disk? Spare Failure (MB)
8 FUJITSU MAT3073NC 0107 Yes No Primary No 70008
9 FUJITSU MAT3073NC 0107 Yes No Out of Sync No 70008
10 FUJITSU MAT3073NC 0107 --- Yes Ok No 70008