beautypg.com

3 iscsi boot configuration, Iscsi boot configuration -5, General parameters – Asus PEB-10G/SFP PLUS/SINGLE User Manual

Page 15

background image

ASUS PEB-10G/SFP+ Series

2-5

2.1.3

iSCSI Boot Configuration

Comprehensive Configuration Management v7.2.14

Copyright (C) 2000-2012 Broadcom Corporation

All rights reserved.

General Parameters

Initiator Parameters

1st Target Parameters

2nd Target Parameters

Secondary Device Parameters

iSCSI Boot Main Menu

Configure General Boot Parameters

[Enter]:Enter Next Menu; [↑|↓]:Next Entry; [ESC]:Quit Menu

Current Adapter:Primary, Bus=03 Device=00 Func=00, MAC=C8:60:00:22:86:B7

General Parameters

TCP/IP Parameters via DHCP [Enabled]

This option applies to IPv4.
[Enabled] The iSCSI boot host software acquires the IP address from the

DHCP server.

[Disabled] The iSCSI boot host software acquires the static IP address.

iSCSI Parameters via DHCP [Enabled]

[Enabled] The iSCSI boot host software acquires its iSCSI target parameters

from the DHCP server.

[Disabled] The iSCSI boot host software acquires its iSCSI target parameters

via the static IP address, which is entered through the iSCSI

Initiator Parameters Configuration screen.

CHAP Authentication [Disabled]

[Enabled] Allows the iSCSI boot host software to use CHAP authentication

when connecting to the iSCSI target. Enter the CHAP ID and

CHAP Secret in the Initiator Parameters configuration screen.

[Disabled] Does not allow the iSCSI boot host software to use CHAP

authentication when connecting to the iSCSI target.

Boot to iSCSI Target [Enabled]

[Enabled] The iSCSI boot host software immediately attempts to boot from

the iSCSI target after successfully connecting to it.

[Disabled] The iSCSI boot host software does not attempt to boot from the

iSCSI target after successfully connecting to it. The control will

then return to the system BIOS so that the next boot device may

be used.

This manual is related to the following products: