Asus PEB-10G/SFP PLUS/SINGLE - Manual (Page 12)

2-2 Chapter 2: Boot Agent Configuration
2.1 Broadcom NetXtreme Ethernet Boot
Agent
The Broadcom NetXtreme Ethernet Boot Agent provides hardware-based Ethernet
card configurations.
To start the Broadcom NetXtreme Ethernet Boot Agent and access the main
screen:
1. Turn on the system. During POST, press when the following screen
appears.
2. The Device List screen appears. Use the up/down arrow key to select an
Ethernet device to configure and press .
Broadcom NetXtreme Ethernet Boot Agent
Copyright (C) 2000-2012 Broadcom Corporation
All rights reserved.
Press Ctrl-S to enter Configuration Menu
Comprehensive Configuration Management v7.2.14
Copyright (C) 2000-2012 Broadcom Corporation
All rights reserved.
<03:00:00> BCM57712 - C8:60:00:22:86:B7 MBA:v7.2.29 CCM:v7.2.14
<03:00:01> BCM57712 - C8:60:00:22:86:B9 MBA:v7.2.29 CCM:v7.2.14
Device List
Select Device to Configure
[Enter]:Enter Next Menu; [↑|↓]:Next Entry; [ESC]:Quit Menu
3. The Main Menu screen appears. Use the up/down arrow key to select an
item and press .
Comprehensive Configuration Management v7.2.14
Copyright (C) 2000-2012 Broadcom Corporation
All rights reserved.
Device Hardware Configuration
MBA Configuration
iSCSI Boot Configuration
Main Menu
Configure MBA Parameters
[Enter]:Enter Next Menu; [↑|↓]:Next Entry; [ESC]:Quit Menu
Current Adapter:Primary, Bus=03 Device=00 Func=00, MAC=C8:60:00:22:86:B7