Asus RS520-X5/PS8 - Manual (Page 32)

Chapter 2: Hardware setup 2-14
2.5 Expansion cards
2.5.1 Installing an expansion card
The barebone server comes with two PCI-E expansion slots, allowing you to install
half-height expansion cards.
Ensure to unplug the power cord before installing or removing expansion cards.
Failure to do so may cause severe damage to the motheboard and other system
components!
To install an expansion card:
1. Remove the two screws on the
metal bracket lock, and then set it
aside.
2. Align the card golden fingers with
the slot, and then press firmly until
the card is completely seated on
the slot.
3. Replace the metal bracket lock,
and secure it with two screws.