Asus P6T SE - Manual (Page 72)

3-16 Chapter 3: BIOS setup
Chapter 3
DRAM WRITE to WRITE Delay(DD) [Auto]
Configuration options: [Auto] [2 DRAM Clock] – [9 DRAM Clock]
DRAM WRITE to WRITE Delay(DR) [Auto]
Configuration options: [Auto] [2 DRAM Clock] – [9 DRAM Clock]
DRAM WRITE to WRITE Delay(SR) [Auto]
Configuration options: [Auto] [4 DRAM Clock] [6 DRAM Clock]
The following ten (10) items are adjusted by typing the desired values using the numeric
keypad and press the key. You can also use the <+> and <-> keys to adjust the
value. To restore the default setting, type [auto] using the keyboard and press the
key.
3.5.7 CPU Voltage [Auto]
Allows you to set the CPU VCore voltage. The values range from 0.85000V to 2.10000V*
with a 0.00625V interval.
• Refer to the CPU documentation before setting the CPU Vcore voltage. Setting a high
VCore voltage may damage the CPU permanently, and setting a low VCore voltage
may make the system unstable.
• The value [2.10000V] of the CPU Voltage item is supported only if the OV_CPU
jumper is enabled. Otherwise the maximum voltage supported is [1.70000V].
See 2. CPU / DRAM Bus / QPI DRAM overvoltage setting on page 2-22 for details.
3.5.8 CPU PLL Voltage [Auto]
Allows you to set the CPU PLL voltage. The values range from 1.80V to 2.50V with a 0.02V
interval.
3.5.9 QPI/DRAM Core Voltage [Auto]
Allows you to set the QPI/DRAM Core voltage. The values range from 1.20000V to
1.90000V* with a 0.00625V interval.
The value [1.90000V] of the QPI/DRAM Core Voltage item is supported only if the OV_
QPI_DRAM jumper is enabled. Otherwise the maximum voltage supported is [1.70000V].
See 2. CPU / DRAM Bus / QPI DRAM overvoltage setting on page 2-22 for details.
3.5.10 IOH Voltage [Auto]
Allows you to set the I/O Hub (IOH) voltage. The values range from 1.10V to 1.70V with a
0.02V interval.
3.5.11 IOH PCIE Voltage [Auto]
Allows you to set the IOH PCIE voltage. The values range from 1.50V to 2.76V with a 0.02V
interval.