Asus SABERTOOTH 990FX/GEN3 R2.0 - Manual (Page 96)

3-26 Chapter 3: BIOS setup
Chapter 3
SB HD Azalia Configuration
The sub-items in this menu allow you to set the SB HD Azalia configuration.
HD Audio Azalia Device [Enabled]
[Enabled] Enables the HD Audio Device.
[Disabled] Disables the controller.
The following two items appear only when you set the HD Azalia Audio Device item to
[Enabled].
Azalia Front Panel [HD]
Allows you to set the front panel audio connector (AAFP) mode to legacy
AC’97 or high-definition audio depending on the audio standard that the
front panel audio module supports.
[AC97]
Sets the front panel audio connector (AAFP) mode to legacy
AC’97
[HD] Sets the front panel audio connector (AAFP) mode to high
definition audio.
SPDIF Out Type [SPDIF]
[SPDIF] Sets to [SPDIF] for SPDIF audio output.
[HDMI] Sets to [HDMI] for HDMI audio output.
3.5.8 APM
Main Ai Tweaker Advanced Monitor Boot Tool
Exit
Allow BIOS to switch off some power
at S5 to get the system ready for ErP
requirement. When set to Enabled, all
other PME options will be switched
off.
Back Advanced\ APM >
UEFI BIOS Utility - Advanced Mode
ErP Ready Disabled
Restore AC Power Loss Power Off
Power On By PME Device Disabled
Power On By Ring Disabled
Power On By RTC Disabled
ErP Ready [Disabled]
This item allows user to switch off some power at S5 to get the system ready for ErP
requirement. When set to [Enabled], all other PME options will be switched off.
Configuration options: [Disabled] [Enabled]
Restore AC Power Loss [Power Off]
[Power On] The system goes into on state after an AC power loss.
[Power Off] The system goes into off state after an AC power loss.
[Last State] The system goes into either off or on state, whatever the system state was
before the AC power loss.