Asus C8HM70-I/HDMI - Manual (Page 43)

ASUS C8HM70-I Series 2-17
2.5.4 System Agent Configuration
Memory Remap Feature [Enabled]
[Enabled] Allow you to enable remapping the memory above 4GB.
[Disabled] Disables this function.
Graphics Configuration
Primary Display [Auto]
Allows you to decide which graphics controller to use as the primary boot device.
Configuration options: [Auto] [iGPU] [PCIE]
iGPU Memory [Auto]
Allows you to select the amount of system memory allocated to DVMT 5.0 used by
the iGPU. Configuration options: [Auto] [32M] [64M] [96M] [128M] ~ [480M] [512M]
[1024M]
Render Standby [Enabled]
Allows you to enable the Intel
® Graphics Render Standby support to reduce the iGPU
power use when idle. Configuration options: [Disabled] [Enabled]
iGPU Multi-Monitor [Disabled]
Allows you to enable or disable the multi-monitor support for both the integrated
Graphics Device and add-on graphic card. The memory size of Internal Graphics
Devicewill be fixed at 64MB. Configuration options: [Disabled] [Enabled]
[AHCI] Set to [AHCI] when you want the SATA hard disk drives to use the AHCI
(Advanced Host Controller Interface). The AHCI allows the onboard storage
driver to enable advanced Serial ATA features that increases storage
performance on random workloads by allowing the drive to internally
optimize the order of commands.
S.M.A.R.T. Status Check [Enabled]
This item only appears when you set SATA Mode Selection to [AHCI] or [IDE]. S.M.A.R.T.
(Self-Monitoring, Analysis and Reporting Technology) is a monitor system. When read/write
of your hard disk errors occur, this feature allows the hard disk to report warning messages
during the POST. Configuration options: [Enabled] [Disabled]
Hot Plug [Disabled]
This item only appears when you set the SATA Mode Selection item to [AHCI] and allows you
to enable or disable the hot-plug support for each SATA port.
Configuration options: [Enabled] [Disabled]