Asus MEW-L - Manual (Page 19)

ASUS MEW-L User’s Manual 19
3. HARDWARE SETUP
Motherboard Settings
3. H/W SETUP
2) I/O Voltage Setting (VIO)
This jumper allows you to select the voltage supplied to the DRAM, chipset,
PCI, and the CPU’s I/O buffer. The default voltage should be used unless pro-
cessor overclocking requires a higher voltage.
Setting
VIO
Normal [1-2] (default)
3.66V [2-3]
MEW-L VIO Setting
Normal Add 0.1 Volt
1 2 3 1 2 3
VIO
01 01 01
®
MEW-L
WARNING! Using a higher voltage may help when overclocking but may result
in the shortening of your computer component’s life. It is strongly recommended
that you leave this setting on its default.
3) Onboard Audio Setting (AUDIO CODEC)
The onboard audio CODEC may be enabled or disabled using all of these jump-
ers. Disable the onboard audio CODEC if you are using an ISA or PCI audio card
on any of the expansion slots or a primary AMR on the AMR slot (see AMR Slot
later in this section). If using an ISA or PCI audio expansion card, Onboard AC’97
Audio Controller in 4.4.2 I/O Device Configuration must also be disabled.
Setting
AUDIO CODEC
Enable [1-2] [1-2] [1-2] [1-2] (default)
Disable [2-3] [2-3] [2-3] [2-3]
MEW-L Audio Codec Setting
Disable Enable
1
2
3
1
2
3
SPK
ADN#
A
UD_EN1
A
UD_EN2
SPK
ADN#
A
UD_EN1
A
UD_EN2
01 01 01
®
MEW-L