Asus P7P55D-E - Manual (Page 80)

3-18 Chapter 3: BIOS setup
Chapter 3
3.5.8 QPI Frequency [Auto]
Allows you to set the QuickPath Interconnect (QPI) frequency.
Configuration options: [Auto] [4270MHz] [4800MHz]
3.5.9 ASUS/3rd Party UI Priority [ASUS Utility]
[ASUS Utility] Prioritizes the usage of ASUS utilities (ASUS EPU, TurboV EVO, etc.).
Other 3rd party OC utilities may not be full-functioned.
[3rd Party Utility] Prioritizes 3rd party OC utilities (IXTU, SetFS, etc.). ASUS utilities can’t be
launched.
3.5.10 OC Tuner [Turbo Profile]
OC Tuner automatically overclocks the frequency and voltage of CPU and DRAM. Choose
[Good Performance] or [Better Performance] as a stable setting for daily use. Choose [Turbo
Profile] as an advanced overclocking setting for special purposes.
Configuration options: [Good Performance] [Better Performance] [Turbo Profile]
3.5.11 Start auto tuning
Press to start auto tuning. It takes around 5 minutes, and the system will reboot for
several times before finish. After auto tuning, the C-State feature will be disabled.
3.5.12 DRAM Timing Control [Auto]
The items in this menu allow you to set the DRAM timing control features.
The configuration options for some of the following items vary depending on the DIMMs depending on the DIMMs
you install on the motherboard.
1st Information: 6-6-6-15-4-36-6-5-16
The values vary depending on your settings of the following sub-items:
DRAM CAS# Latency [Auto]
Configuration options: [Auto] [3 DRAM Clock] [4 DRAM Clock] – [10 DRAM Clock] [11
DRAM Clock]
DRAM RAS# to CAS# Delay [Auto]
Configuration options: [Auto] [3 DRAM Clock] [4 DRAM Clock] – [14 DRAM Clock] [15
DRAM Clock]
DRAM RAS# PRE Time [Auto]
Configuration options: [Auto] [3 DRAM Clock] [4 DRAM Clock] – [14 DRAM Clock] [15
DRAM Clock]
DRAM RAS# ACT Time [Auto]
Configuration options: [Auto] [3 DRAM Clock] [4 DRAM Clock] – [30 DRAM Clock] [31
DRAM Clock]
DRAM RAS# to RAS# Delay [Auto]
Configuration options: [Auto] [1 DRAM Clock] – [7 DRAM Clock]