Asus MEW-AML - Manual (Page 24)

24 ASUS MEW-AML User’s Manual
13) CPU Fan Connectors (3-pin CPU_FAN)
This connector supports a cooling fan of 350mA (4.2 Watts) or less. Orientate
the fan so that the heat sink fins allow airflow to go across the onboard heat
sink(s) instead of the expansion slots. Depending on the fan manufacturer, the
wiring and plug may be different. The red wire should be positive, while the
black should be ground. Connect the fan’s plug to the board taking into consid-
eration the polarity of the connector.
NOTE: The “Rotation” signal cannot be monitored on this motherboard.
WARNING! The CPU and/or motherboard will overheat if there is no airflow
across the CPU and onboard heatsinks. Damage may occur to the motherboard
and/or the CPU fan if these pins are incorrectly used. These are not jumpers,
do not place jumper caps over these pins.
MEW-AML 12-Volt Cooling Fan Power
GND
Rotation
+12V
CPU Fan Power
1
MEW-AML
The following PANEL illustration is used for items 14-21
MEW-AML System Panel Connectors
* Requires an ATX power supply.
IDELED-
Keylock +5V Speaker
Speaker
Connector
Power LED
Ground
Reset SW
HDLED
Message LED
ExtSMI#
Reset
Ground Ground
Keyboard Lock
ATX Power
Switch*
PWRBTN
Ground
IDELED+
PWRLED+ PWRLED- PWRLED-
MSGLED+ MSGLED- Ground
External SMI Lead
1
MEW-AML
3. HARDWARE SETUP
Connectors
3. H/W SETUP