Asus P5KPL-AM SE - Manual (Page 51)

ASUS P5KPL-AM SE 2-13
AI Overclocking [Auto]
Allows selection of CPU overclocking options to achieve desired CPU internal frequency.
Select either one of the preset overclocking configuration options:
Manual - allows you to individually set overclocking parameters.
Auto - loads the optimal settings for the system.
Overclock Profile - loads overclocking profiles with optimal parameters for stability
when overclocking.
Test Mode - loads overclock (overclocking 5%) with spread spectrum.
The following item appears only when you set the AI Overclocking item to [Manual].
CPU Frequency [xxx]
Displays the frequency sent by the clock generator to the system bus and PCI bus. The
value of this item is auto-detected by the BIOS. Use the <+> and <-> keys to adjust the CPU
frequency. You can also type the desired CPU frequency using the numeric keypad. The
values range from 133 to 600. Refer to the table below for the correct Front Side Bus and
CPU External Frequency settings.
The following item appears only when you set the AI Overclocking item to [Overclock
Profile].
Overclock Options [Overclock 5%]
Allows selection of CPU overclocking options to achieve desired CPU internal frequency.
Configuration options: [Overclock 5%] [Overclock 10%] [Overclock 15%] [Overclock 20%]
[Overclock 30%]
DRAM Frequency [Auto]
Allows you to set the DDR2 operating frequency.
Configuration options (for 1600MHz FSB CPU): [Auto] [800MHz] [960MHz] [1000MHz]
[1200MHz]
Configuration options (for 1333MHz FSB CPU): [Auto] [667MHz] [800 MHz] [1000 MHz]
[1100MHz]
Configuration options (for 1066MHz FSB CPU): [Auto] [667MHz] [800 MHz] [1066 MHz]
Configuration options (for 800MHz FSB CPU): [Auto] [667MHz] [800 MHz]
Selecting a very high DRAM frequency may cause the system to become unstable! If this
happens, revert to the default setting.
1.8V Dual Over Voltage [Auto]
Manually set memory voltage or set to Auto for safe mode.
Configuration options: [Auto] [1.80V] [2.00V] [2.25V]
VTT_CPU Over Voltage [Auto]
Manually set FSB Termination Voltage or set to Auto for safe mode.
Configuration options: [Auto] [1.2V] [1.3V]