Asus TX97-L - Manual (Page 13)

ASUS TX97-L User’s Manual 13
III. INSTALLATION
Jumpers
1) BBLKW p. 15 Flash ROM Boot Block Program (Disable/Enable)
2) CLRTC p. 15 Real Time Clock RAM (Clear Data)
3) KBWK p. 16 Keyboard Power Up (Enable/Disable)
4) FS0, FS1, FS2 p. 16 CPU External Clock (BUS) Frequency Selection
5) BF0, BF1, BF2 p. 16 CPU:BUS Frequency Ratio
6) VID0, VID1, VID2 p. 18 CPU Voltage Selection
Expansion Slots
1) DIMM Sockets p. 19 168-Pin DIMM Memory Expansion Sockets
2) CPU ZIF Socket 7 p. 22 Central Processing Unit (CPU) Socket
3) SLOT 1, 2, 3 p. 23 16-bit ISA Bus Expansion Slots *
4) PCI 1, 2, 3, 4 p. 23 32-bit PCI Bus Expansion Slots
Connectors
1) KB p. 25 Keyboard Connector (5-pin Female)
2) FLOPPY p. 25 Floppy Drive Connector (34-1pin Block)
3) PRINTER p. 26 Parallel (Printer) Port Connector (26-1pin Block)
4) COM1, COM2 p. 26 Serial Port COM1 & COM2 (10-1pin Blocks)
5) FAN p. 27 Power Supply, Chassis, CPU Fan Power Leads
6) CHASSIS p. 27 Chassis Open Alarm Lead (4-1pin Block)
7) Primary / Second IDE p. 28 Primary / Secondary IDE Connector (40-1pin Blocks)
8) IDELED p. 28 IDE LED Activity Light
9) ATX POWER p. 29 ATX Motherboard Power Connector (20-pin Block)
10) AT POWER p. 29 AT Motherboard Power Connector (12-pin Block)
11) USBIRMS p. 31 PS/2 Mouse/USB/IR Combo-Connector (18-1pin Block)
12) IR p. 31 Second Infrared Port Module Connector (5-pin Block)
13) MSG.LED (PANEL) p. 31 System Message LED (2 pins)
14) SMI (PANEL) p. 31 SMI Switch Lead (2 pins)
15) PWR SW. (PANEL) p. 31 ATX Power & Soft-Off Switch Lead (2 pins)
16) RESET (PANEL) p. 31 Reset Switch Lead (2 pins)
17) PWR.LED (PANEL) p. 31 System Power LED Lead (3 pins)
18) KEYLOCK (PANEL) p. 31 Keyboard Lock Switch Lead (2 pins)
19) SPEAKER (PANEL) p. 31 Speaker Output Connector (4 pins)
20) W0LCON p. 32 Wake on LAN Activity Connector (3-pins)
* The onboard hardware monitor uses the address 290H-297H so legacy ISA cards
must not use this address or else conflicts will occur.
(Map of Board)
III. INST
ALLA
TION