Asus P2E-B - Manual (Page 32)

32 ASUS P2E-B User’s Manual
III. INSTALLATION
(Connectors)
III. INST
ALLA
TION
18. ATX Power Supply Connector (ATXPWR, 20-pins)
This connector connects to a ATX power supply. The plug from the power supply
will only insert in one orientation because of the different hole sizes. Find the
proper orientation and push down _ërmly making sure that the pins are aligned.
IMPORTANT: Make sure that your ATX power supply can supply at least
10mAmp on the 5-volt standby lead (5VSB). You may experience difficulty in
powering on your system if your power supply cannot support the load. For
Wake on LAN support, your ATX power supply must supply at least 720mAmp.
R
P2E-B ATX Power Connector
+3.3V
olts
-12.0V
olts
Ground Power Supply On Ground Ground Ground -5.0 V
olts
+5.0 V
olts
+5.0 V
olts
Power Good
+12.0V
olts
+3.3 V
olts
+3.3 V
olts
Ground
+5.0 V
olts
Ground
+5.0 V
olts
Ground
+5V Standby
19. AT Power Supply Connector (POWER, 12-pins)
This connector connects to a standard 5 Volt power supply. To connect the leads
from the power supply, ensure first that the power supply is not plugged. Most
power supplies provide two plugs (P8 and P9), each containing six wires, two of
which are black. Orient the connectors so that the black wires are together.
R
P2E-B AT Power Connector
Power Plugs from
Power Supply
P9 P8
RED RED RED WHT BLK BLK BLK BLK BLU YL
W RED ORG
Power Connector
on Motherboard
PG
+12V GND
-5V
-12V +5V
+5V
Using a slight angle, align the plastic guide pins on the lead to their receptacles
on the connector. Once aligned, press the lead onto the connector until the lead
locks into place.