Asus T2-R - Manual (Page 34)

34 Chapter 2: Basic installation
6. Connect the 4-pin power plug to the power connector of the floppy
disk drive.
7. Connect the 4-pin power plug(s) to the power connector of the optical
drive(s).
8. Connect the 4-pin power plug to the power connector of the hard disk
drive.
2.10.1 Voltage selector
The PSU has a 115V/230V voltage selector
switch located at the side of the power socket.
Use this switch to select the appropriate voltage
according to the voltage supply in your area.
If the voltage supply in your area is 100-127V,
set the switch to 115V.
If the voltage supply in your area is 200-240V,
set the switch to 230V.
230
Setting the switch to 115V in a 230V environment will seriously
damage the system!
Power supply unit plugs
1
6
7 8
1