Asus T2-R - Manual (Page 30)

30 Chapter 2: Basic installation
8. Connect a power plug from the
power supply unit to the power
connector at the back of the
optical drive.
9. Connect one end of the IDE
ribbon cable to the IDE
interface at the back of the
optical drive, matching the red
stripe on the cable with Pin 1 on the IDE interface.
10. Connect one end of the optical drive audio cable to the 4-pin
connector at the back of the optical drive.
11. Connect the other end of the IDE ribbon cable to the secondary IDE
connector (black connector labeled SEC_IDE) on the motherboard.
See page 53 for the location of the secondary IDE connector.
12. Connect the other end of the audio cable to the black 4-pin connector
labeled CD1 on the motherboard. See page 53 for the location of the
CD connector.
13. Re-install the front panel cover
by aligning its hooks with the
holes on the chassis.
8
9 10
14. Snap the front panel cover
hooks to the chassis holes as
indicated.
13
14