Asus T2-R - Manual (Page 29)

29 ASUS Terminator 2 barebone system
2.8 Installing a second optical drive
The system comes with a pre-installed optical drive (DVD-RW, DVD-ROM,
CD-RW, or CD-ROM) and an empty 5.25-inch drive bay for a second
optical drive.
To install a second optical drive:
1. Place the chassis upright.
2. Locate the front panel cover
hooks.
3. Press the hooks inward to
release the front panel cover
from the chassis.
4. Detach the front panel cover top
hooks.
5. Push the the front panel cover
slightly outwards to detach it from
the chassis, then set it aside.
1
2
3
Set your second optical drive as Slave device before connecting the
IDE cable and power plug. Refer to the optical drive documentation on
how to set the drive as a Slave device.
3
3
3
4
4
6. Carefully push the optical drive
to the bay until its screw holes
are aligned with the holes on the
bay. Refer to the illustration.
7. Secure the optical drive with two
screws on one side of the bay.
6 7
5