Asus F1A55 - Manual (Page 34)

3. Serial ATA 3.0 Gb/s connectors (7-pin SATA3G_1~6)
These connectors are for the Serial ATA 3.0 Gb/s signal cables for Serial ATA hard
disk drives and optical disc drives. If you installed Serial ATA hard disk drives, you can
create a RAID 0, RAID 1, or RAID 10 configuration through the onboard controller.
• These connectors are set to IDE mode by default. In IDE mode, you can connect Serial
ATA boot/data hard disk drives to these connectors. If you intend to create a Serial ATA
RAID set using these connectors, set the type of the SATA connectors in the BIOS to
[RAID]. See section 2.5.2 SATA Configuration for details.
• You must install Windows ® XP Service Pack 3 or later version before using Serial
ATA hard disk drives. The Serial ATA RAID feature is available only if you are using
Windows ® XP SP3 or later version.
• When using hot-plug and NCQ, set the type of the SATA connectors in the BIOS to
[AHCI]. See section 2.5.2 SATA Configuration for details.
4. Serial port connector (10-1 pin COM1)
This connector is for a serial (COM) port. Connect the serial port module cable to this
connector, then install the module to a slot opening at the back of the system chassis.
The COM module is purchased separately.
F1A55
SATA3G_1 SATA3G_2
GN
D
RSATA_RXP1 RSATA_RXN1 GN
D
RSATA_TXN1 RSATA_TXP1 GN
D
GN
D
RSATA_RXP2 RSATA_RXN2 GN
D
RSATA_TXN2 RSATA_TXP2 GN
D
SATA3G_3 SATA3G_4
GN
D
RSATA_RXP
3
RSATA_RXN
3
GN
D
RSATA_TXN
3
RSATA_TXP
3
GN
D
GN
D
RSATA_RXP
4
RSATA_RXN
4
GN
D
RSATA_TXN
4
RSATA_TXP
4
GN
D
SATA3G_5 SATA3G_6
GN
D
RSATA_RXP
5
RSATA_RXN
5
GN
D
RSATA_TXN
5
RSATA_TXP
5
GN
D
GN
D
RSATA_RXP
6
RSATA_RXN
6
GN
D
RSATA_TXN
6
RSATA_TXP
6
GN
D
F1A55 SATA 3.0Gb/s connectors
F1A55
F1A55 Serial port (COM1) connector
PIN 1
COM1
Chapter 1: Product introduction 1-22