Asus A7V600 - Manual (Page 28)

1-18 Chapter 1: Motherboard Information
3. Clear RTC RAM (CLRTC)
These jumpers allow you to clear the Real Time Clock (RTC) RAM in CMOS.
You can clear the CMOS memory of date, time, and system setup parameters
by erasing the CMOS RTC RAM data. The RAM data in CMOS is powered by
the onboard button cell battery.
To erase the RTC RAM:
1. Turn OFF the computer and unplug the power cord.
2. Remove the battery.
3. Move the jumper cap to pin [1-2] to clear CMOS then replace the jumper
cap back to pin [2-3] after 3 seconds.
4. Re-install the battery.
5. Plug the power cord and turn ON the computer.
6. Hold down the key during the boot process and enter BIOS setup
to re-enter data.
A7V600
®
A7V600 Clear RTC RAM
CLRTC
Normal Clear CMOS
(Default)
1
2 2
3
4. V
CORE
over-voltage (3-pin OVER_VOLT1)
When enabled, this jumper allows CPU V
CORE
ranges of 1.7V to 2.05V.
When this jumper is disabled, V
CORE
setting has a range of +1.5V to +1.85V.
You may adjust the CPU V
CORE
through the BIOS Setup.
Setting to a very high core voltage may cause permanent damage to the CPU.
It is recommended that you keep the default setting (Disable).
2 1 2 3
A7V600
®
A7V600 OVER_VOLT Setting
OVER_VOLT1
Enable
(Default)
Disable