beautypg.com

1 boot device priority, 2 boot settings configuration, 3 security – Asus M2A74-AM SE User Manual

Page 38: Boot device priority -14, Boot settings configuration -14, Security -14

background image

2-14

ASUS M2A74-AM SE

2.6.1

Boot Device Priority

1st ~ xxth Boot Device

These items specify the boot device priority sequence from the available devices. The

number of device items that appears on the screen depends on the number of devices

installed in the system. Configuration options: [Removable Device] [Hard Drive]

[ATAPI CD-ROM ] [Disabled]

2.6.2

Boot Settings Configuration

Quick Boot [Enabled]

Enabling this item allows the BIOS to skip some power on self tests (POST) while booting to

decrease the time needed to boot the system. When set to [Disabled], BIOS performs all the

POST items. Configuration options: [Disabled] [Enabled]

Full Screen Logo [Enabled]

This allows you to enable or disable the full screen logo display feature.

Configuration options: [Disabled] [Enabled]

Set this item to [Enabled] to use the ASUS MyLogo 2™ feature.

2.6.3

Security

The Security menu items allow you to change the system security settings. Select an item

then press to display the configuration options.

Change Supervisor Password

Select this item to set or change the supervisor password. The Supervisor Password item

on top of the screen shows the default Not Installed. After you set a password, this item

shows Installed.

To set a Supervisor Password:
1.

Select the Change Supervisor Password item then press .

2.

From the password box, type a password composed of at most six letters and/or

numbers, then press .

3.

Confirm the password when prompted.

AddOn ROM Display Mode [Force BIOS]

Sets the display mode for option ROM. Configuration options: [Force BIOS] [Keep Current]

Bootup Num-Lock [On]

Allows you to select the power-on state for the NumLock. Configuration options: [Off] [On]

Wait for ‘F1’ If Error [Enabled]

When set to Enabled, the system waits for the F1 key to be pressed when error occurs.

Configuration options: [Disabled] [Enabled]

Hit ‘DEL’ Message Display [Enabled]

When set to Enabled, the system displays the message Press DEL to run Setup during

POST. Configuration options: [Disabled] [Enabled]