beautypg.com

Asus M3N-HT Deluxe/Mempipe User Manual

Page 50

background image

2-26

Chapter 2: Hardware information

M3N-HT DELUXE

PRI_IDE

NOTE:Orient the red markings
on the IDE ribbon cable to PIN 1.

PIN1

M3N-HT DELUXE IDE connector

2. IDE connector (40-1 pin PRI_IDE)

The onboard IDE connector is for the Ultra DMA 133/100/66 signal cable.
There are three connectors on each Ultra DMA 133/100/66 signal cable:
blue, black, and gray. Connect the blue connector to the motherboard’s IDE
connector, then select one of the following modes to configure your device.

Pin 20 on the IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect insertion when you
connect the IDE cable.

Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.

If any device jumper is set as “Cable-Select,” make sure all other device
jumpers have the same setting.

Drive jumper setting

Mode of

device(s)

Cable connector

Single device

Cable-Select or Master

Black

Two devices

Cable-Select

Master

Black

Slave

Gray

Master

Master

Black or gray

Slave

Slave

This manual is related to the following products: