Asus P6T Deluxe - Manual (Page 64)

ASUS Q-Connector (system panel)
You can use the ASUS Q-Connector to connect/disconnect chassis front panel
cables in a few steps. Refer to the instructions below to install the ASUS
Q-Connector.
2. Install the ASUS Q-Connector to the
system panel connector, making sure
the orientation matches the labels on the
motherboard.
3. The front panel functions are now
enabled. The figure shows the
Q-Connector properly installed on the
motherboard.
1. Connect the front panel cables to the
ASUS Q-Connector.
Refer to the labels on the Q-Connector
to know the detailed pin definitions, then
match them to the respective front panel
cable labels.
The labels of the front panel
cables may differ from chassis
made by different manufacturers.
2-38 Chapter 2: Hardware information