Asus P8Q67-M DO/TPM - Manual (Page 28)

ASUS P8Q67-M DO Series 1-18
12. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch. Connect
one end of the chassis intrusion sensor or switch cable to this connector. The chassis
intrusion sensor or switch sends a high-level signal to this connector when a chassis
component is removed or replaced. The signal is then generated as a chassis intrusion
event.
By default, the pin labeled “Chassis Signal” and “Ground” are shorted with a jumper
cap. Remove the jumper caps only when you intend to use the chassis intrusion
detection feature.
13. Speaker connector (4-pin SPEAKER)
The 4-pin connector is for the chassis-mounted system warning speaker. The speaker
allows you to hear system beeps and warnings.
P8Q67-M DO/USB3
P8Q67-M DO/USB3 Chassis intrusion connector
+5VSB_M
B
Chassis Signal GN
D
CHASSIS
P8Q67-M DO/USB3
P8Q67-M DO/USB3 Speaker Out Connector
+5
V
GN
D
GN
D
Speaker Out
SPEAKER
PIN 1